iOS App >
Android App >
The Springulator® features four different types of compression spring calculators, which check spring stress and provide spring design information. With only a few required fields of input, the Springulator lets you check:
The Springulator is able to generate a variety of data to assist with the design of your compression spring. Depending on your spring type, enter the load or rate information plus the total coils (Nt), the free length (L), the wire diameter (d) and the mean diameter (D) to calculate data including your compression springs:
By selecting your material type, the Springulator compression spring calculator is also able to check your design to see if it falls within allowable stress limitations. Click the button and a stress chart will be generated that shows the acceptable stress limitations, and pinpoints the stress at different load heights, as applicable to the type of compression spring you are calculating.
The Springulator compression spring calculator is designed for engineers, designers and purchasing agents. It has been built with a number of checks that will not allow you to calculate a spring if the data you have entered will not result in a feasible design. If you aren't sure the Springulator is operating correctly, please enter the data and check the results on the sample values and results page.
Compression spring calculations are affected by the type of spring end. Compression spring ends affect the performance of your spring, so be sure to consult with your Newcomb Spring representative to determine the best end type for your application. Learn more about compression spring ends types in our main web site technical articles.
Compression Spring with Closed Ends,
Compression Spring with Closed & Ground Ends,
Compression Spring with Open Ends,
Compression Spring with Open & Ground Ends,
If your compression spring "screws" into another mating part, it is important to consider the direction of the spring's wind. Compression springs can be left wound or right wound. To determine a compression spring's direction of wind simply hold the spring in your hand with your fingers placed around the outside of the body and your thumb pointing straight up. If the last coil ends in the same direction that your fingers are pointing, that is the hand (direction of wind) of the spring. Read more on wind direction of a compression spring.
Our online technical article archive includes a variety of information that may assist in your spring design.
Read more about:
The Springulator is a useful tool for users who wish to check the stress of a design, calculate compression spring functions and test spring capabilities. Please note all results are for design purposes only and are not guaranteed accurate. Click here to begin to use the Springulator compression spring calculator.
for spring design
support or to
request a quote.
© Newcomb Spring Corp